Description : In use and daily maintenance, we should pay attention to the following points to extend the service life of the steering machine: 1. When driving on the potholed and uneven road, slow down and reduce the load borne by the steering gear. Steering Rack And Pinion 26465 For 2005-2009 Nissan Quest Se Mini Passenger Description : In use and daily maintenance, we should pay attention to the following points to extend the service life of the steering machine: 1. When driving on the potholed and uneven road, slow down and reduce the load borne by the steering gear. 2. Frequently check the protective sleeves on both sides of the steering machine and the protective sleeves on the upper part of the steering machine connected with the universal cross. The damage of the sheath is the main factor that causes the early wear and damage of the steering gear . After the sheath is damaged, water and dust and sand will enter the steering gear through the damaged part, damaging the lubricating grease film of the gear rack, resulting in rust, abnormal wear and other phenomena inside the steering gear . If the internal water and sand are not disposed of immediately, the steering gear will be scrapped in a short time. Therefore, check the status of the dust-proof sheath at least once a month. If the sheath is damaged, it must be replaced immediately, and the steering machine shall be comprehensively inspected and maintained before replacement. 3. After the toe in is adjusted by four-wheel positioning and the steering rod is changed, pay special attention to the deformation and improper assembly of the protective sleeve, otherwise the protective sleeve will be damaged. 4. The lubricating grease will gradually become dirty and deteriorated during use, which will reduce the lubricating capacity; meanwhile, the materials under wear will gradually increase, and the wear phenomenon of abrasive particles will become more and more serious, which will aggravate the wear of steering gear . Every 100000 km or so, the steering gear shall be fully maintained, cleaned and re greased. 5. Due to the poor service conditions and heavy load, the steering gear must be equipped with special lubricating grease, which can not meet the use requirements. 6. The middle clearance of the steering wheel will gradually increase in use. If the left and right empty stroke of the steering wheel exceeds 15 degrees, the steering wheel must be inspected. If the abnormal wear of the gear rack is serious, the steering wheel assembly must be replaced. If there is no abnormal wear, but the clearance is too large, it can be adjusted. During the adjustment, it shall be carried out by trained professionals at the service station. After the adjustment, it shall be ensured that the steering wheel can be turned left and right to the limit position, with even force and flexible rotation. 7. Do not carry out the maintenance and repair of the steering machine at the roadside shop with simple equipment and low technical level. If the steering machine is not adjusted properly, it will cause jamming and endanger the driving and personal safety. el. If the steering machine is not adjusted properly, it will cause jamming and endanger the driving and personal safety. Fits the Following Vehicles: NISSAN QUEST 2004 - 2009 All Models YES Item Specifics Brand lujuntec Manufacturer Part Number TO10883601S Part Type Rack & Pinion Complete Unit,Steering Rack,Steering Gear Performance Part Yes Installation method Performance/Custom Fitment Type Performance/Custom Material High Quality Steel Surface Finish Polished, Rust Protected Manufacturer Warranty 3 Years Vintage Car Part Yes Rack Type Hydraulic Greasable or Sealed YES Other Part Number Steering gear Rack Material corrosion and rust prevention Note Backed by satisfying after-sales service Advantage Rotate quickly and normal position Interchange Part Number 26-3026,26465 Superseded Part Number 49001-CK000 OE/OEM Part Number rack replacement kit,rack and pinion,power rack parts OE Number Power Steering Rack,Steering Rack and Pinion Sub Type Rack and Pinion Assembly, Rack and Pinion Rack Gear Package Dust plug Universal Fitment No Itment Note Top performance For long service life Mounting Hardware Included As the picture Fits 2007 Nissan Quest S Mini Passenger Van 4-Door 3.5L For 2006 Nissan Quest Base Mini Passenger Van 4-Door 3.5L Feature ESCP Payment We accept paypal only We only ship to verified PayPal addresses. Please make sure your PayPal address is verified and up to date before sending payment. We cannot change any address after checkout has been completed. Please make sure you submit your correct address! About Shipping 1. Items will be shipped within 24 hours after getting your verified payment. 2. US Storage& UNITED STATES by fast shipping.We offer 24 hours dispatch and estimated delivery time is 3-5 business days.except weekend and other irresistible factors.Please feel free to contact us if you haven't receive the item after the estimated shipping time About Return • We will gladly accept your return within 30 days of the original purchase. • Our return process is simple and fast: 1. We will pay for the return shipping label if you received a broken / defective item(s) or the item(s) doesn't match our description. As soon as we receive the item(s) back we will process a refund for the item(s) which was/were returned. 2. You will be required to pay for the return shipping label if you changed your mind or no longer need the item(s). As soon as we receive the item(s) back we will process a refund for the item(s) which was/were returned. • If we'll receive a package back because of the incorrect address, the refund will be processed excluding our shipping cost. Fitment Notes Please consult with your mechanic, or contact us, if you are not sure of fitment for your vehicle. READ the notes on the compatibility chart. We are not responsible for incompatible items due to buyer's error, and a restocking fee as well as shipping charges will be deducted from returns or exchanges. DESCRIPTION PAYMENT SHIPPING RETURN POLICY CONTACT US Shop Category Store Home Brake Rotors & Pads ◈ Brake Rotors ◈ Brake Pads ◈ Brake Rotors and Pads Towing Mirrors Wheel Hub Bearing Timing Belt Kits Door Handle Wheel Spacers Water Pump Fuel Pumps Fuel Injector Car Seat Cover Suspension Kit ◈ suspension kit-cj ◈ Suspension Kit okx ◈ Suspension Kit fu Leveling lift kit Wheel Lug Nuts ABS Wheel Speed Sensor Knock Sensor Air Cleaner Filter Box Hot Item Fits 1997-2003 Ford F-150 4.2L 4.6L 5.4L Performance Fuel Pump Assembly USD 35.49 Leveling Lift Kit For Chevrolet Silverado 1500 2007-2022 Lift 3" Front 2" Rear USD 86.76 Pair Manual Towing Mirrors for 99-07 Chevy Silverado GMC Sierra Truck 1500 2500 USD 67.99 Leveling Lift Kit For Ford F-150 Pickup 2004-2020 2014 Lift 3" Front and 2" Rear USD 72.29 For Honda Civic 02-04 DX EX HX GX 2001-2005 1.7L Timing Belt kit & Water Pump USD 41.23 Delivery New List Item For Nissan Altima 02-06 Maxima 04-06 Manual Front Right CV Axle Shaft Assembly USD 93.19 Window Regulator With Motor For 2007-2015 Mazda CX-199 Front Passenger Side USD 45.17 For Dodge Magnum V8 5.7L 6.1L 2005 2006 2007 2008 Throttle Body USD 54.29 4X CV Axles For Polaris Ranger 800 Midsize 400 2013-14 Front & Rear Left Right USD 204.79 Throttle Body For Buick Regal Sportback 2.0L 2018-2020 Cadillac ATS 2013-2019 USD 64.89 Help & Info Payment Policy Shipping Policy Return Policy FAQ About Us Steering Rack And Pinion 26465 For 2005-2009 Nissan Quest Se Mini Passenger Description : In use and daily maintenance, we should pay attention to the following points to extend the service life of the steering machine: 1. When driving on the potholed and uneven road, slow down and reduce the load borne by the steering gear. 2. Frequently check the protective sleeves on both sides of the steering machine and the protective sleeves on the upper part of the steering machine connected with the universal cross. The damage of the sheath is the main factor that causes the early wear and damage of the steering gear . After the sheath is damaged, water and dust and sand will enter the steering gear through the damaged part, damaging the lubricating grease film of the gear rack, resulting in rust, abnormal wear and other phenomena inside the steering gear . If the internal water and sand are not disposed of immediately, the steering gear will be scrapped in a short time. Therefore, check the status of the dust-proof sheath at least once a month. If the sheath is damaged, it must be replaced immediately, and the steering machine shall be comprehensively inspected and maintained before replacement. 3. After the toe in is adjusted by four-wheel positioning and the steering rod is changed, pay special attention to the deformation and improper assembly of the protective sleeve, otherwise the protective sleeve will be damaged. 4. The lubricating grease will gradually become dirty and deteriorated during use, which will reduce the lubricating capacity; meanwhile, the materials under wear will gradually increase, and the wear phenomenon of abrasive particles will become more and more serious, which will aggravate the wear of steering gear . Every 100000 km or so, the steering gear shall be fully maintained, cleaned and re greased. 5. Due to the poor service conditions and heavy load, the steering gear must be equipped with special lubricating grease, which can not meet the use requirements. 6. The middle clearance of the steering wheel will gradually increase in use. If the left and right empty stroke of the steering wheel exceeds 15 degrees, the steering wheel must be inspected. If the abnormal wear of the gear rack is serious, the steering wheel assembly must be replaced. If there is no abnormal wear, but the clearance is too large, it can be adjusted. During the adjustment, it shall be carried out by trained professionals at the service station. After the adjustment, it shall be ensured that the steering wheel can be turned left and right to the limit position, with even force and flexible rotation. 7. Do not carry out the maintenance and repair of the steering machine at the roadside shop with simple equipment and low technical level. If the steering machine is not adjusted properly, it will cause jamming and endanger the driving and personal safety. el. If the steering machine is not adjusted properly, it will cause jamming and endanger the driving and personal safety. Fits the Following Vehicles: NISSAN QUEST 2004 - 2009 All Models YES Payment About Shipping About Return Fitment Notes We accept paypal only We only ship to verified PayPal addresses. Please make sure your PayPal address is verified and up to date before sending payment. We cannot change any address after checkout has been completed. Please make sure you submit your correct address! 1. Items will be shipped within 24 hours after getting your verified payment. 2. US Storage& UNITED STATES by fast shipping.We offer 24 hours dispatch and estimated delivery time is 3-5 business days.except weekend and other irresistible factors.Please feel free to contact us if you haven't receive the item after the estimated shipping time • We will gladly accept your return within 30 days of the original purchase. • Our return process is simple and fast: 1. We will pay for the return shipping label if you received a broken / defective item(s) or the item(s) doesn't match our description. As soon as we receive the item(s) back we will process a refund for the item(s) which was/were returned. 2. You will be required to pay for the return shipping label if you changed your mind or no longer need the item(s). As soon as we receive the item(s) back we will process a refund for the item(s) which was/were returned. • If we'll receive a package back because of the incorrect address, the refund will be processed excluding our shipping cost. Please consult with your mechanic, or contact us, if you are not sure of fitment for your vehicle. READ the notes on the compatibility chart. We are not responsible for incompatible items due to buyer's error, and a restocking fee as well as shipping charges will be deducted from returns or exchanges. All right reserved.
Specifics
- Advantage: Rotate quickly and normal position
- Brand: lujuntec
- Feature: ESCP
- Fitment Type: Performance/Custom
- Fits: 2007 Nissan Quest S Mini Passenger Van 4-Door 3.5L
- For: 2006 Nissan Quest Base Mini Passenger Van 4-Door 3.5L
- Greasable or Sealed: YES
- Installation method: Performance/Custom
- Interchange Part Number: 26-3026,26465
- Itment Note: Top performance For long service life
- Manufacturer Part Number: TO10883601S
- Manufacturer Warranty: 3 Years
- Material: High Quality Steel
- Mounting Hardware Included: As the picture
- Note: Backed by satisfying after-sales service
- OE Number: Power Steering Rack,Steering Rack and Pinion
- OE/OEM Part Number: rack replacement kit,rack and pinion,power rack parts
- Other Part Number: Steering gear
- Package: Dust plug
- Performance Part: Yes
- Rack Material: corrosion and rust prevention
- Rack Type: Hydraulic
- Sub Type: Rack and Pinion Assembly, Rack and Pinion Rack Gear
- Superseded Part Number: 49001-CK000
- Surface Finish: Polished, Rust Protected
- Type: Rack & Pinion Complete Unit,Steering Rack,Steering Gear
- UPC: Does not apply
- Universal Fitment: No
- Vintage Part: Yes
- gtin13: Does not apply